MHDD下无法读取硬盘的处理方法

第一步:先退出MHDD，然后用DIR命令看看，在当前目录里右一个CFG的目录，输入CD CFG，进入这个目录。

第二步：输入EDIT MHDD.CFG 命令，编辑MHDD.CFG文件。

第三步：看到下面这两行代码以后，

#PRIMARY_ENABLED=FALSE

#AUTODETECT_ENABLED=FALSE

将这两行代码里的FALSE改为TRUE。

第四步：按ALT键，按回车，弹出菜单，然后选保存，再退出。

第五步：输入CD .. 命令，退回到MHDD目录，输入MHDD命令，进入MHDD程序，看看你的硬盘是否已经被识别到了。

                               
登录/注册后可看大图

                               
登录/注册后可看大图

                               
登录/注册后可看大图

MHDD is a very good hard drive testing tool, for display as "X" of the bad sectors, you can easily write down a list of defects. MHDD can only detect the hard disk-based settings, and the tools to support the PC3000 card, you can receive the PC3000 card hard to carry out the operation. But when you enter the MHDD, the input PORT command, or press SHIFT + 3F, but found it impossible to identify to your hard disk, and the CMOS actually able to identify to your hard disk. Here to tell you the solution.

The first step: the first from the MHDD, and then use the DIR command to see if, in the current directory was the right one CFG directory, type CD CFG, into the directory.

Step two: Enter the command EDIT MHDD.CFG, edit documents MHDD.CFG.

The third step: see the following two lines of code, the

# PRIMARY_ENABLED = FALSE

# AUTODETECT_ENABLED = FALSE

These two lines of code changed to FALSE in the TRUE.

Step four: press ALT key, press Enter, pop-up menu, and then choose Save, then exit.

Fifth Step: Enter the command CD .., back to the MHDD directory, enter the command MHDD entered MHDD procedures to see whether your hard disk to be identified.